Abstract
The determination of inhomogeneous material properties of bone in finite element analysis is currently based on two converting formulae that convert the computed tomography number into bone density and then into Young's modulus. However, there are variations between studies and no standardized set of formulae exists. The objective of the current study was to propose a procedure for the determination of Young's modulus of cortical bone directly from computed tomography using a rabbit model. Three‐point bending experiments and finite element analyses were used to derive a formula for converting the computed tomography number into Young's modulus. The formula was found to be E=0.8324×(CT)1.057, where E is the Young's modulus, and CT is the computed tomography number. The correlation coefficient between finite element analysis results based on the above formula and the experimental results was found to be 0.973. The proposed procedure was found to be feasible, and it has the advantage of saving computational time. Similar conversion formulae can be derived for human bone when cadaveric bones are available. Such formulae can simplify the procedure for determining the inhomogeneous material properties of cortical bone directly from computed tomography.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.