Determination of the measuring position in laser-Doppler anemometry

Abstract

The present paper is concerned with the determination of the measuring position of a laser-Doppler anemometer (LDA) relative to a wall. The proposed method is based on the finding that the output of a hot-wire anemometer increases when the wire, which is mounted in quiescent air parallel to the wall, is brought closer than 800 μm to the wall. For given hot-wire anemometer parameters, the hot-wire anemometer output voltage depends on the wall material and the wire distance from the wall. After suitable calibration for the wall material of the test section, the anemometer reading in a test rig can be used to find the wire position. Moving the measuring volume of a LDA-system across the wire yields an output voltage variation of the LDA-photomultiplier showing a Gaussian shape. When the maximum output voltage is reached, the centre of the measuring control volume is located at the centre of the wire and, hence, the location of the LDA-measuring position is known. All position measurements for the LDA-system are then taken relative to this point using the scale of the LDA-traversing system. If optical effects of transparent test section walls are eliminated by employing refractive index matched liquids, there are other ways to find the measuring position of a laser-Doppler anemometer relative to a wall. One such method and its application to the study of the turbulent near wall flow in a pipe is described in this paper.