Determination of the Interfacial Characteristics of a Series of Bolaamphiphilic Poly(fluorooxetane) Surfactants through Molecular Dynamics Simulation

Abstract

Constant surface tension (NgammaT) and constant volume (NVT) molecular dynamics simulations have been conducted on a series of bolaamphiphilic alpha,varpi-(diammonium disulfato)poly(fluorooxetane)s and on a typical "long-chain" anionic fluorosurfactant used to improve the flow-and-leveling characteristics of aqueous coatings, to compare their behavior at a water/air interface. Recent research has shown that the poly(fluorooxetane) surfactants considered in this paper could serve as an effective substitute for traditional fluorosurfactants used in flow-and-leveling applications.(1) From molecular dynamics simulation, we have determined the saturated interfacial area per surfactant, interfacial area per surfactant as a function of surface tension, density profiles, the degree of hydration for various atoms in each surfactant, the degree of counterion binding, and order parameters. Our results for saturated interfacial area per surfactant molecule are greater than what has been obtained by other researchers through parametric fitting of interfacial area from experimental surface tension data using the Davies isotherm. Possible explanations for this difference are discussed. The low interfacial areas occupied by each poly(fluorooxetane) at the water/air interface are the result of their ability to adopt a "looped" conformation, in which the carbon and oxygen backbone of each surfactant and the attached perfluoroalkyl chains are forced into the air phase. A geometrically defined penetration parameter was calculated from the density profiles, which reveals that each poly(fluorooxetane) surfactant is more effective at separating the air and water phases than the "long-chain" anionic fluorosurfactant. The degree of hydration measured for different atoms in poly(fluorooxetane) during simulation confirms that a "looped" conformation is adopted in which the surfactant backbone and the perfluoroalkyl chains are lifted away from the water surface. Calculation of order parameters revealed a much lower degree of ordering for the perfluoroalkyl side chains in each bolaamphiphile than in the "long chain" anionic fluorosurfactant. When viewed in the context of the penetration parameter analysis, the density profiles and hydration data suggest why each poly(fluorooxetane) is capable of significantly reducing surface tension when other fluorosurfactants with similarly short perfluoroalkyl moieties provide inadequate surface tension reduction for practical flow-and-leveling applications.