Determination of the heat transfer coefficient from short‐shots studies and precise simulation of microinjection molding

Abstract

AbstractThe filling process of a micro‐cavity was analyzed by modeling the compressible filling stage by using pressure‐dependent viscosity and adjusted heat transfer coefficients. Experimental filling studies were carried out at the same time on an accurately controlled microinjection molding machine. On the basis of the relationship between the injection pressure and the filling degree, essential factors for the quality of the simulation can be identified. It can be shown that the flow behavior of the melt in a micro‐cavity with a high aspect ratio is extremely dependent on the melt compressibility in the injection cylinder. This phenomenon needs to be considered in the simulation to predict an accurate flow rate. The heat transfer coefficient between the melt and the mold wall that was determined by the reverse engineering varies significantly even during the filling stage. With increasing injection speed and increasing cavity thickness, the heat transfer coefficient decreases. It is believed that the level of the cavity pressure is responsible for the resulting heat transfer between the polymer and the mold. A pressure‐dependent model for the heat transfer coefficient would be able to significantly improve the quality of the process simulation. POLYM. ENG. SCI., 2010. © 2009 Society of Plastics Engineers