Abstract
This paper deals with a new method of strain measurement applied to the experimental determination of the forming limit diagrams of thin steel sheets. This method uses the correlation technique to determine the displacement field between two images taken on the same area of the sample at two different strain levels. The strains are calculated from this field. The range of strains determined between two images may be very wide. This allows to compare the initial image to one before the sample fracture or two successive images during the straining. This method shows that the strain localization may occur early during the forming process and so the onset of localized necking is not a sudden phenomenon. A method is proposed to draw the forming limit diagrams for necking.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.