Abstract
Room temperature uniaxial tensile and biaxial Viscous Pressure Bulge (VPB) tests were conducted for five Advanced High Strength Steels (AHSS) sheet materials, and the resulting flow stress curves were compared. Strain ratios ( R-values) were also determined in the tensile test and used to correct the biaxial flow stress curves for anisotropy. The pressure vs. dome height raw data in the VPB test was extrapolated to the burst pressure to obtain the flow stress curve until fracture. Results of this work show that the flow stress data can be obtained to higher strain values under biaxial state of stress. Moreover, it was observed that some materials behave differently if subjected to different state of stress. These two conclusions, and the fact that the state of stress in actual stamping processes is almost always biaxial, suggest that the bulge test is a more suitable test for obtaining the flow stress of AHSS sheet materials for use as an input to Finite Element (FE) simulation models.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
