Determination of the basic friction angle ϕb of joints using the field tilt test: results of various “fast” tests on outcrops

Abstract

The basic friction angle of rock joints is usually obtained from tilt tests, being the most common the laboratory tilt tests. This test has been standardized according to the ISRM. However, most of the times when calculating the shear strength of discontinuities, reference tables are used to obtain the basic friction value for the lithology under study. These tables omit some lithologies complicating the search of adequate references. An alternative, straightforward and economical way to obtain ϕb is through the field tilt test, which is carried out by sliding two blocks aside a joint. It is a well-known test, but there are few references to its implementation. In this test, unlike the laboratory tilt test, the samples are not “polished” and it is necessary to evaluate the roughness of the joint and the normal component to the weight of the upper blocks. The idea is to calculate the term of ϕb from the Barton-Bandis’ equation and include the tilt angle α. Various tilt-test measurements were carried out with field blocks on both sides of the same joint, considering different lithologies (granite, limestone, andesite, dacite, coal and slate) and block sizes, evaluating the ideal ranges of applicability of the test.