Abstract
Abstract In a search for a rapid and accurate method for determining sulfur in rubber it was found that oxidation of the sample by means of sodium peroxide in the Parr bomb is unsatisfactory when the sulfur content of the rubber is low because the samples that can be used for this purpose are too small for accurate results, or, if larger samples are used, the oxidation is incomplete. The use of a mixture of nitric and perchloric acids, as described by Kahane, is also unsatisfactory; but with certain modifications the method may be made to yield very good results, and if fusions are unnecessary, it will save time and labor. The chief modifications recommended are the use of a more dilute solution of nitric acid (equal volumes of the concentrated acid and water), allowing the rubber to dissolve completely on the steam bath before heating more strongly, then heating to gentle boiling until oxidation is complete, and finally destroying the residual nitric acid by means of hydrochloric acid. The use of a large...
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
