Determination of submicron aerosols effective density using two-stage low-pressure impactor and aerosol electrometer based on pre-measured particle size distribution

Abstract

A novel methodology was presented for determining the representative effective density of aerosols of a given size distribution, using a lab-made two-stage low-pressure impactor and an aerosol electrometer. Electrical currents upstream (Imeasured, up) and downstream (Imeasured, down) of the 2nd stage of the impactor were measured using a corona charger and the aerosol electrometer. In addition, the electrical currents upstream (Icalculated, up) and downstream (Icalculated, down) of the 2nd stage of the impactor were calculated using the aerosol charging theory. Then, the difference between the ratio of Imeasured,down to Imeasured,up and the ratio of Icalculated,down to Icalculated,up was iterated with varying the presumed effective density until the difference was smaller than 0.001. The methodology was validated using poly-disperse sodium chloride (NaCl) particles. The effective densities of ambient aerosols were then obtained from indoor and outdoor environments and compared with those calculated from a relation between mobility (scanning mobility particle sizer (SMPS) measurement) and aerodynamic (electrical low-pressure impactor (ELPI) measurement) diameters. Compared to the effective densities obtained with SMPS and ELPI measurements, the effective densities obtained using the methodology introduced in this paper differed within 10 % deviation, depending on measurement location. After an averaged effective density for given size distribution is obtained at a measurement location, the number-based size distribution can be easily converted to mass-based size distribution using the representative effective density.