Abstract

The objective of this study was to perform a tensile test on isotropic and orthotropic plates with holes and measured deformations around their hole by using the method of digital image correlation (DIC). The results of this measure were used to determine the local stress at the edge of the hole and measured the net and global stress concentration factor for isotropic and orthotropic materials and see the difference between the two types of materials.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.