Determination of strain around distal implants as abutments for partial and fixed implant-supported prostheses with posterior cantilever.

Abstract

This study aimed to compare strain around implants used as abutments for removable partial dentures with wrought wires and fixed partial dentures with ball attachments and fixed dentures with posterior cantilever. An edentulous mandibular model was constructed using epoxy resin with four parallel implants in the area between the two mental foramina. Four strain gauges were attached to the buccal, lingual, mesial, and distal aspects of each implant. One fixed prosthesis with cantilever and two removable partial dentures were considered as prosthetic treatments. A vertical 500-N force was applied with 10-N intervals. The maximum strain in the fixed prosthesis was higher than that of the partial removable denture; in the removable denture with a wrought wire arm, it was higher than that in the denture with a ball attachment (P < 0.001). The lowest rate of strain was recorded on the mesial aspect (P < 0.05). However, the highest rate of strain was recorded on the lingual and distal aspects of the removable denture with a wrought wire in the buccal aspect and the removable prosthesis with the ball attachment on the buccal and lingual aspects (P < 0.05). Finally, despite minor differences in the maximum strain rate in each implant position, the differences were not statistically significant (P > 0.05). Partial removable denture with a ball attachment decreased strain more than that by the removable portal denture with a wrought wire arm. The worst type of prosthesis in terms of the overall strain rate was the fixed prosthesis with cantilever.