Abstract
SUMMARY The estimation of shear wave velocity and attenuation in near-surface geology is of primary importance in engineering seismology. In fact, their knowledge is essential for site response studies when preparing improved seismic hazard scenarios. In this study, we propose two approaches for estimating the average shear wave quality factor Qs by using recordings of a vertical array of accelerometers. The methods are mainly based on the deconvolution of the wavefield recorded in a borehole with that recorded at the surface. The first method requires the Fourier transform of the deconvolved wavefield to be fitted with a theoretical transfer function valid for the vertical or nearly vertical (in the case at hand up to 30 ◦ incidence angle) propagation of S waves. The second method is based on the spectral fitting of the Fourier transform of only the acausal part of the deconvolved wavefield with a theoretical transfer function. Both methods can be applied without any prior knowledge of the subsoil structure (since they are based on empirical data analysis) and do not require a precise knowledge of the azimuthal orientation of the sensors in the boreholes (which is seldom available). First, we describe the theoretical framework of the proposed methodologies for Qs estimation, which are based on the assumption that the structure in the borehole is weakly heterogeneous in the vertical direction (i.e. no large impedance contrast exists between the borehole sensor and the surface). Second, by using synthetic accelerograms, we verify that in a realistic subsoil structure, the assumption of vertical homogeneity can hold and we investigate the robustness and the suitability of the proposed methods. Finally, only the method that was shown to provide the more stable results, based on fitting the borehole-to-surface spectral ratio with a theoretical function, is applied to earthquakes signals recorded by a vertical array of accelerometers installed in Atak¨ oy (western Istanbul). Results show that using borehole data provides a fair and robust estimate of an average Qs (of about 30, 46 and 99 for the 0–50, 0–70, 0–140 m depth ranges, respectively) that can be used for numerical simulations of ground motion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have