Determination of Residual Stresses in Roll Compacted Titanium Strips

Abstract

Manufacturing processes typically produce residual stresses. The residual stresses can be advantageous when they are compressive and detrimental when tensile. In roll compaction of metal powder, similarly to rolling solid metals, substantial residual stresses can be generated. In roll compaction of metal powders, few studies have been done to identify the presence of any residual stresses, their effects on the process that produced them and subsequent processes. In this study, residual stress induced during roll compaction of titanium strips were measured for strips of different densities. The different densities were achieved by rolling two different particle size (100 and 325 mesh) titanium powders varying the roll gap (0.1, 0.3 and 0.5mm) and the set strip width (20, 50, 100mm). The roll speed was kept constant at 10rpm while three feed rates were employed i.e. 15g/s for 20mm strip width, 30g/s for 50mm strip width, and 60g/s for 100mm strip width. The strips were evaluated for surface residual stresses using x-ray diffraction (XRD) surface probing technique. Preliminary results were obtained for the surface residual stress at the center of the titanium strips for the 100 and 325 mesh strips rolled at 0.1 roll gap for 20 and 50mm set width. Results show the presence of largely compressive residual stresses. The largest surface residual stress of -55MPa was recorded corresponding to a compaction density of 83%. The corresponding maximum shear stress was 27MPa. Lower green density resulted in progressively more tensile residual stresses although all stresses remained compressive for the investigated parameters.