Abstract
Cast ASTM F75 femoral knee implant components distort during manufacture due to residual stress re-distribution or inducement. These castings pose a number of challenges for residual stress determination methods; they have a complex geometry, their microstructure is inhomogeneous, they work-harden rapidly and they have a coarse, elastically anisotropic grain structure. The contour method is anticipated to be the most promising residual stress determination technique. X-ray diffraction is feasible for components which have experienced plastic deformation on their surface which results in refined diffracting domains. Centre-hole drilling is feasible, but the influence of stress induced from drilling and the effect of coarse grain structure is unknown. Neutron diffraction is challenging also due to a coarse grain structure and difficult nuclear material properties.This paper is part of a Themed Issue on Measurement, modelling and mitigation of residual stress.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.