Abstract
The transmission paths of vibration from the factory floor of the board mill to the ‘floating’ floor of the control room were identified using vibration intensity measurements. The method proved to be useful although the bending stiffness of the floor was not known exactly. The usual vibration measurements did not give any clues about the attachments between the floor of the control room and the floor of the mill.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.