Determination of muscle strength and function in plesiosaur limbs: finite element structural analyses of Cryptoclidus eurymerus humerus and femur.

Abstract

BackgroundThe Plesiosauria (Sauropterygia) are secondary marine diapsids. They are the only tetrapods to have evolved hydrofoil fore- and hindflippers. Once this specialization of locomotion had evolved, it remained essentially unchanged for 135 Ma. It is still controversial whether plesiosaurs flew underwater, rowed, or used a mixture of the two modes of locomotion. The long bones of Tetrapoda are functionally loaded by torsion, bending, compression, and tension during locomotion. Superposition of load cases shows that the bones are loaded mainly by compressive stresses. Therefore, it is possible to use finite element structure analysis (FESA) as a test environment for loading hypotheses. These include muscle reconstructions and muscle lines of action (LOA) when the goal is to obtain a homogeneous compressive stress distribution and to minimize bending in the model. Myological reconstruction revealed a muscle-powered flipper twisting mechanism. The flippers of plesiosaurs were twisted along the flipper length axis by extensors and flexors that originated from the humerus and femur as well as further distal locations.MethodsTo investigate locomotion in plesiosaurs, the humerus and femur of a mounted skeleton of Cryptoclidus eurymerus (Middle Jurassic Oxford Clay Formation from Britain) were analyzed using FE methods based on the concept of optimization of loading by compression. After limb muscle reconstructions including the flipper twisting muscles, LOA were derived for all humerus and femur muscles of Cryptoclidus by stretching cords along casts of the fore- and hindflippers of the mounted skeleton. LOA and muscle attachments were added to meshed volumetric models of the humerus and femur derived from micro-CT scans. Muscle forces were approximated by stochastic iteration and the compressive stress distribution for the two load cases, “downstroke” and “upstroke”, for each bone were calculated by aiming at a homogeneous compressive stress distribution.ResultsHumeral and femoral depressors and retractors, which drive underwater flight rather than rowing, were found to exert higher muscle forces than the elevators and protractors. Furthermore, extensors and flexors exert high muscle forces compared to Cheloniidae. This confirms a convergently evolved myological mechanism of flipper twisting in plesiosaurs and complements hydrodynamic studies that showed flipper twisting is critical for efficient plesiosaur underwater flight.