Determination of copper, iron and vanadium in petroleum by direct sampling electrothermal atomic absorption spectrometry

Abstract

A procedure for the direct determination of Cu, Fe and V in petroleum samples by electrothermal atomic absorption spectrometry using a solid sampling accessory, without any sample pre-treatment or dilution, is proposed. A Pd + Triton X-100 solution was used as chemical modifier. The pyrolysis and atomization temperatures, as well as the Pd mass were defined by multivariate optimization. The other parameters of the temperature programs were defined by univariate optimization. The limits of detection at the optimized conditions were 10, 200 and 800 pg for Cu, Fe and V, respectively, for typical sample masses ranging from 0.10 to 3.00 mg. Method accuracy was confirmed by the analysis of oil certified reference materials as well as by comparison with independent methods. Aqueous calibration solutions were used and no statistically significant difference (analysis of variance) was observed between obtained and expected values.