Abstract
This work is aimed at determining solubility of CO 2 in polymer melt through experimental measurements. The apparent solubility of CO 2 in two kinds of isotactic polypropylene (iPP) melts with different molecular weight distributions was measured by using a magnetic suspension balance (MSB) at temperatures of 200 and 220 °C, and CO 2 pressures up to 30 MPa. Meanwhile, the swelling volume of the iPP/CO 2 solutions was experimentally measured under the same conditions by using a high-pressure view cell with direct visual observation. It was then used to correct the gas buoyancy acting on the iPP melts in the MSB measurement so that the real solubility of CO 2 in the iPP melts could be determined. Solubility of CO 2 in the iPP melts was also corrected using swelling ratio predicted by Sanchez–Lacombe equation of state (S–L EOS) for comparison. iPP with a larger molecular weight distribution showed a lower swelling degree and lower real solubility than those of iPP with a lower molecular weight distribution. It showed a large deviation to the solubility with the experimental swelling ratio correction at high CO 2 pressures due to the overestimation of swelling ratio predicted by Sanchez–Lacombe (S–L) equation of state.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
