Determination of CCT Diagram by Dilatometry Analysis of High-Strength Low-Alloy S960MC Steel.

Abstract

High-strength steels are used more than general structural steel due to their combination of properties such as high strength, good toughness and weldability. They are mainly used in the manufacture of heavy vehicles for the mining industry, cranes, transportation, etc. However, welding these grades of steel brings new challenges. Also, a simulation for welding high-strength steel is required more often. To insert a material database into the simulation program, it is necessary to conduct investigations using CCT (Continuous Cooling Transformation) diagrams, welded joints research, and more. To investigate the behavior of S960MC steel during heating and cooling, we used dilatometry analysis supported by EBSD (Electron Backscatter Diffraction) analysis. A CCT diagram was constructed. The transformation temperatures of Ac1 and Ac3 increase with increasing heating rate. The Ac1 temperature increased by 54 °C and the Ac3 temperatures by 24 °C as the heating rate increased from 0.1 °C/s to 250 °C/s. The austenite decomposition temperatures have a decreasing trend in the cooling phase with increasing cooling rate. As the cooling rate changes from 0.03 °C/s to 100 °C/s, the initial transformation temperature drops from 813 °C to 465 °C. An increase in the cooling rate means a higher proportion of bainite and martensite. At the same time, the hardness increases from 119 HV10 to 362 HV10.