Abstract
An electrical analogue method is introduced to determine optimum blank shapes for deep-drawing cups of irregular cross-section. Square and rectangular cups were drawn from aluminium and steel blanks having these shapes and required very little trimming. Comparison is made with other methods of developing blanks and although one empirical method gave reasonable results for rectangular cups it is concluded that the electrical analogue method is preferred; it is also applicable to irregularly shaped cups.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
