Abstract
A combination of optical and tomographic imaging techniques for inspection of local surface roughness and specular gloss of black prints and coated paper are introduced. A diffractive optical-element-based glossmeter (DOG) and a low-coherence interferometer (LCI) were used to obtain local information about the print in terms of topographic and gloss maps. X-ray microcomputed tomography (μCT) was used to obtain 3D local structural information of the coated paper. Gloss and topographic maps were used to determine statistical gloss and roughness parameters. These parameters were useful when analysing the surface condition of prints and coated paper. We found an orientation-dependent gloss slope, which reflects the fact that gloss does not depend on the surface roughness alone. Slope parameters turned out to be particularly sensitive to surface properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
