Abstract
An inverse heat conduction problem in a superconducting radio frequency (SRF) cavity is examined. A localized defect is simulated as a point-heating source on the inner surface (RF surface) of the evacuated niobium cavity. Liquid helium acts as a coolant on the outer surface of the cavity. By measuring the outer surface temperature profile of the cavity using relatively few sensors, the temperature and location of a hot spot on the inner surface of the niobium are calculated using an inverse heat conduction technique. The inverse method requires a direct solution of a three-dimensional heat conduction problem through the cavity wall thickness along with temperature measurements from sensors on the outer surface of the cavity, which is immersed in liquid helium. A non-linear parameter estimation program then estimates the unknown location and temperature rise of the hot spot inside the cavity. The validation of the technique has been done through an experiment conducted on a niobium sample at room temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
