Detection of groundwater aquifers using geoelectrical resistivity method (case study : Plupuh Sub-district, Sragen District )

Abstract

An aquifer is a layer below the ground surface that contains groundwater. Inside the earth there are unconfined aquifers and confined aquifers, where unconfined aquifers are located near the surface while confined aquifers are located very deep beneath the earth. This study aims to find the location, depth, and thickness of aquifers that have the potential to contain large amounts of groundwater. The instrument used in this research is a resistivity meter OYO Model 2119C Mc OHM-EL, with a Schlumberger configuration with a current electrode length of AB/2 to 350 meters. Data acquisition were carried out in the Plupuh sub-district, Sragen district as many as 5 sounding points, and data processing using IP2win software. Based on the interpretation of resistivity geoelectrical data, it can be concluded that the area has the potential to have a lot of groundwater content, for unconfined aquifers at the TS1 sounding point with a depth of 7.7 meters to 19.2 meters with a thickness of 11.5 meters. and TS4 with a depth of 15.4 meters to 30 meters with a layer thickness of 14.6 meters. This aquifer layer is dominated by sand layer lithology, while the confined aquifer layer is located around TS1 and TS2. The two sounding points are located in the east and northeast of the research area. TS1 was detected at a depth of 39.9 meters to 110 meters with a layer thickness of 60.1 meters and TS2 was at a depth of 40.2 meters to 66.5 meters and 80.2 meters to 139.7 meters with a thickness of 84.8 meters. This aquifer layer is dominated by the gravel sand layer in TS1 and the sand layer in TS2.