Abstract
This paper presents some preliminary investigation of electromagnetic radiation (EMR) emissions from (1-x)(Bi0.5Na0.5TiO3)–x(BaTiO3) (x = 0.04, 0.05, 0.06, 0.07 & 0.08) lead-free piezoelectric ceramics. Compositions near the morphotropic phase boundary 0.94(Bi0.5Na0.5TiO3)–0.06(BaTiO3) (BNT-6BT) are studied. The electromagnetic radiations were detected with the help of non–contacting loop antenna placed around the sample. EMR voltage detection was done simultaneously when the piezoelectric material was subjected to alternating electric field. Digital storage oscilloscope was used to measure the EMR voltage. At highest applied alternating electric field of 5.8 kV/cm EMR Signal of 17.6 V was detected for 0.95(Bi0.5Na0.5TiO3)–0.05(BaTiO3) (BNT-5BT). Higher frequency of the electric field leads to the higher acceleration of the dipoles of the piezoelectric material and thus leads to the higher amplitude of EMR. The EMR Voltage is observed to be proportional to the polarization and this can lead to the development of new technique of measuring extent of polarization. Also the EMR phenomenon can be used to develop sensors for non-contact excessive deformation measurement.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
