Detection, Estimation of Magnitude, and Relative Location of Weak Aftershocks Using Waveform Cross-Correlation: The Earthquake of August 7, 2016, in the Town of Mariupol

Abstract

The study of the stress-strain state of a medium in seismically quiet areas is difficult because of the absence of strong events. Under such circumstances, each earthquake, even relatively weak, is of high importance. In this case, all possible information on tectonic stresses and their dynamics, e.g., information on time, location, and magnitude of aftershocks, should be obtained from available seismic data. The earthquake near the town of Mariupol which occurred on August 7, 2016, had a body wave magnitude of 4.5–4.9 from the data of the different seismological centers. We detected 12 aftershocks that occurred within 5 days after the main shock using two seismic arrays (AKASG and BRTR) and one three-component station (KBZ) of the International Monitoring System, as well as two array stations of the Institute of Geosphere Dynamics, Russian Academy of Sciences. For six aftershocks, signals were found at three or more stations. The other aftershocks were detected from the data at two out of three nearest stations. Signal detection and association with aftershocks of the main shock, as well as estimation of magnitude and relative location of the found aftershocks, were carried out using the method of waveform cross-correlation (WFCC). The signals from the main shock that acted as the only master event (ME) for the WFCC method were used as waveform templates. To increase the signal-to-noise ratio and to determine the exact onset time of regular seismic waves from aftershocks, we used waveform templates of different length, from 10 to 180 s depending on the wave type and distance to the station, as well as band filtering in narrow frequency bands. The highest sensitivity of the detector and accuracy of the P-wave onset time estimates were reached when a waveform template included all regular waves from P to L g . Association of signals with aftershocks was based on back projection of signal arrival times to origin times using the travel time from a master event to the station, which was measured with a very low error, being equal to almost half of the digitization step length. To develop a seismic event hypothesis, the origin times at two or more stations should be spaced within a 2-s interval.