Detecting COVID-19 patients via MLES-Net deep learning models from X-Ray images

Abstract

BackgroundCorona Virus Disease 2019 (COVID-19) first appeared in December 2019, and spread rapidly around the world. COVID-19 is a pneumonia caused by novel coronavirus infection in 2019. COVID-19 is highly infectious and transmissible. By 7 May 2021, the total number of cumulative number of deaths is 3,259,033. In order to diagnose the infected person in time to prevent the spread of the virus, the diagnosis method for COVID-19 is extremely important. To solve the above problems, this paper introduces a Multi-Level Enhanced Sensation module (MLES), and proposes a new convolutional neural network model, MLES-Net, based on this module.MethodsAttention has the ability to automatically focus on the key points in various information, and Attention can realize parallelism, which can replace some recurrent neural networks to a certain extent and improve the efficiency of the model. We used the correlation between global and local features to generate the attention mask. First, the feature map was divided into multiple groups, and the initial attention mask was obtained by the dot product of each feature group and the feature after the global pooling. Then the attention masks were normalized. At the same time, there were two scaling and translating parameters in each group so that the normalize operation could be restored. Then, the final attention mask was obtained through the sigmoid function, and the feature of each location in the original feature group was scaled. Meanwhile, we use different classifiers on the network models with different network layers.ResultsThe network uses three classifiers, FC module (fully connected layer), GAP module (global average pooling layer) and GAPFC module (global average pooling layer and fully connected layer), to improve recognition efficiency. GAPFC as a classifier can obtain the best comprehensive effect by comparing the number of parameters, the amount of calculation and the detection accuracy. The experimental results show that the MLES-Net56-GAPFC achieves the best overall accuracy rate (95.27%) and the best recognition rate for COVID-19 category (100%).ConclusionsMLES-Net56-GAPFC has good classification ability for the characteristics of high similarity between categories of COVID-19 X-Ray images and low intra-category variability. Considering the factors such as accuracy rate, number of network model parameters and calculation amount, we believe that the MLES-Net56-GAPFC network model has better practicability.