Abstract
AbstractExperimental results are presented to show that there are very significant differences in the mean gas void fractions measured in an open tube and a annular gap bubble column, when operated at the same gas superficial velocity, using a porous sparger. Measurements were carried out in a vertical 0.102 m internal diameter column, with a range of concentric inner tubes to form an annular gap, giving diameter ratios from 0.25 to 0.69; gas superficial velocities in the range 0.014–0.200 m/s were investigated. The mean gas void fraction decreases with increasing ratio of the inner to outer diameter of the annular gap column and the transition to heterogeneous flow occurs at lower gas superficial velocities and lower void fractions. Two reasons are proposed and validated by experimental investigations: (1) the presence of the inner tube causes large bubbles to form near the sparger, which destabilise the homogeneous bubbly flow and reduce the mean void fraction; this was confirmed by deliberately injecting large bubbles into a homogeneous dispersion of smaller bubbles, and (2) the shape of the void fraction profiles changes with gap geometry and this affects the distribution parameter in the drift‐flux model. Both of these effects serve to reduce the mean gas void fraction in an annular gap bubble column compared to an open tube at the same gas superficial velocity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have