Abstract
ABSTRACT Biosorption is an efficient and cost-effective method for heavy metals’ remediation. However, saturated biosorbents may pose a serious problem for the environment. Flax fibres have shown very good adsorption capacities to remove zinc, copper and lead ions from contaminated aqueous solutions. In this study, adsorption–desorption cycles were conducted with loaded flax fibres in batch mode to recover heavy metals using four types of solutions: hydrochloric acid solution, nitric acid solution, sodium hydroxide solution and ultrapure water. Desorption kinetic studies, conducted with loaded flax fibres, showed very fast desorption of zinc, copper and lead when using nitric and hydrochloric acids with a selectivity sequence of Zn (totally desorbed) > Cu (94%) > Pb (80–73%). Desorption kinetic was slower with the use of sodium hydroxide and showed much lower desorption rates of Zn (62%) > Pb (12%) > Cu (7%). Desorption of zinc and copper from previously loaded fibres from binary metal ion system in lead solution was also investigated. Different concentrations ranging from 0.04 to 0.20 mmol/L were tested. The obtained results demonstrated a significant release in the order Zn (18–90%) > Cu (2–42%), while lead was still efficiently adsorbed. Retention efficiencies of zinc and copper and adsorption efficiency of lead resulted in the same adsorption efficiencies of the three metal ions onto flax fibres in the ternary metal ion system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.