Abstract
Forging is one of the production methods of turbine blades. But because of the complexities of the blades, they cannot be produced in one stage and it is necessary to perform preform. In this paper, an extruded elliptical cross section was considered as blade preform, then response surface method (RSM) was applied to optimise this preform. The maximum filling ratio of final die and the minimum strain variance of final blade were considered as objective of optimisation. Design expert software was used for design of experiment and optimisation, also Deform-3D software was applied to simulate the forging process. The optimised preform was compared with the preform resulted from conventional preform designing method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Mechatronics and Manufacturing Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.