Abstract
Particle-stabilized liquid foams provide a general route for producing low-density macroporous materials from melt-processable and intractable thermoplastic polymers. In this paper, we demonstrate how these liquid foams can be used to design macroporous polymers with tailored microstructures and properties by adjusting the various processing parameters. By varying the size, concentration, and wettability of the particles in the colloidal suspensions and controlling the frothing, drying, and sintering conditions, macroporous materials with porosities between 33 and 95% and median pore sizes (D50) between 13 and 634 μm were obtained. This foaming process is applicable to a wide range of hydrophobic materials and is demonstrated here on commercially available polymeric powders of poly(tetrafluoroethylene) (PTFE), poly(vinylidene fluoride) (PVDF), poly(ether imide) (PEI), and poly(ether ether ketone) (PEEK).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.