Design, Simulation, and Mechanical Testing of 3D-Printed Titanium Lattice Structures

Abstract

Lattice structure topology is a rapidly growing area of research facilitated by developments in additive manufacturing. These low-density structures are particularly promising for their medical applications. However, predicting their performance becomes a challenging factor in their use. In this article, four lattice topologies are explored for their suitability as implants for the replacement of segmental bone defects. The study introduces a unit-cell concept for designing and manufacturing four lattice structures, BCC, FCC, AUX, and ORG, using direct melt laser sintering (DMLS). The elastic modulus was assessed using an axial compression strength test and validated using linear static FEA simulation. The outcomes of the simulation revealed the disparity between the unit cell and the entire lattice in the cases of BCC, FCC, and AUX, while the unit-cell concept of the full lattice structure was successful in ORG. Measurements of energy absorption obtained from the compression testing revealed that the ORG lattice had the highest absorbed energy (350 J) compared with the others. The observed failure modes indicated a sudden collapsing pattern during the compression test in the cases of BCC and FCC designs, while our inspired ORG and AUX lattices outperformed the others in terms of their structural integrity under identical loading conditions.