Abstract
An antenna that mainly consists of a square dual-layer dielectric substrate and a metal patch etched with a bowtie-shaped slot is proposed. The bowtie-shaped and elliptical structures on both sides are used to extend the electrical length and hence yield a miniaturization effect. Simulated results show that the 5G frequency band of 3.3-3.6 GHz can be achieved in the condition of| S11|<-10 dB. A good radiation pattern with low back lobe and low cross-polarization level is achieved over the entire operating frequency band. Owing to the multi-layer printed circuit board (PCB) technology, the proposed structure is simple and at the low manufacturing cost. The antenna with good performances can be used in the 5G base station.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.