Abstract
Eurocode EN 1994-1-1 currently covers design of concrete-filled steel tubular (CFST) columns using normal strength materials with nominal steel yield strength (fy) not more than 460 MPa and concrete characteristic cylinder strength less than 50 MPa. As high strength materials have been increasingly used in construction, this paper aims to extend current design equation for square and rectangular CFSTs in EN 1994-1-1 to incorporate high strength materials. A comprehensive experimental database consisting of 443 square and rectangular CFST stub column test results was developed. Statistical evaluations were undertaken and the results indicate that the current cross-section slenderness limit for square and rectangular CFSTs is too conservative and can be safely relaxed from 52235/fy to 68235/fy. The design equation could be extended to incorporate high strength materials). Then, a reliability analysis in accordance with EN 1990 was performed to evaluate the applicability of the proposed design method. It was found that the current partial factors are safe for the design of square and rectangular CFSTs with normal strength materials even after relaxation of the cross-section slenderness limit. However, modification should be applied to the existing design equation for the design of high strength materials to yield an acceptable safety level. Finally, an experimental investigation on 10 stub column tests was carried out to further verify the applicability of the proposed design recommendation. It was found that the proposed design recommendation yields satisfactory predictions when compared to test results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.