Design of radio frequency power amplifier for 2.45 GHz IoT application using 0.18 µm CMOS technology

Abstract

PurposeThe purpose of this study is to show that due to the emergence of the Internet of Things (IoT) industry in recent years, the demand for the higher integration of wireless communication systems with a higher data rate of transmission capacity and lower power consumption has increased tremendously. The radio frequency power amplifier (PA) design is getting more challenging and crucial. A PA for a 2.45 GHz IoT application using 0.18 µm complementary metal oxide semiconductor (CMOS) technology is presented in this paper.Design/methodology/approachThe design consists of two stages, the driver and output stage, where both use a single-stage common source transistor configuration. In view of performance, the PA can deliver more than 20 dB gain from 2.4 GHz to 2.5 GHz.FindingsThe maximum output power achieved by PA is 13.28 dBm. As the PA design is targeted for Bluetooth low energy (BLE) transmitter use, a minimum of 10 dBm output power should be achieved by PA to transmit the signal in BLE standard. The PA exhibits a constant output third-order interception point of 18 dBm before PA becomes saturated after 10 dBm output power. The PA shows a peak power added efficiency of 17.82% at the 13.24 dBm output power.Originality/valueThe PA design exhibits good linearity up to 10 dBm out the PA design exhibits good linearity up to 10 dBm output power without sacrificing efficiency. At the operating frequency of 2.45 GHz, the PA exhibits a stability k-factor, the value of more than 1; thus, the PA design is considered unconditional stable. Besides, the PA shows the s-parameters performance of –7.91 dB for S11, –11.07 dB for S22 and 21.5 dB for S21.