Abstract

The synthesis of four mononuclear heptacoordinated organotin (IV) complexes of mixed ligands derived from tridentated Schiff bases and pyrazinecarboxylic acid is reported. This organotin (IV) complexes were prepared by using a multicomponent reaction, the reaction proceeds in moderate to good yields (64% to 82%). The complexes were characterized by UV-vis spectroscopy, IR spectroscopy, mass spectrometry, 1H, 13C, and 119Sn nuclear magnetic resonance (NMR) and elemental analysis. The spectroscopic analysis revealed that the tin atom is seven-coordinate in solution and that the carboxyl group acts as monodentate ligand. To determine the effect of the substituent on the optoelectronic properties of the organotin (IV) complexes, thin films were deposited, and the optical bandgap was obtained. A bandgap between 1.88 and 1.98 eV for the pellets and between 1.23 and 1.40 eV for the thin films was obtained. Later, different types of optoelectronic devices with architecture “contacts up/base down” were manufactured and analyzed to compare their electrical behavior. The design was intended to generate a composite based on the synthetized heptacoordinated organotin (IV) complexes embedded on the poly(3,4-ethylenedyoxithiophene)-poly(styrene sulfonate) (PEDOT:PSS). A Schottky curve at low voltages (<1.5 mV) and a current density variation of as much as ~3 × 10−5 A/cm2 at ~1.1 mV was observed. A generated photocurrent was of approximately 10−7 A and a photoconductivity between 4 × 10−9 and 7 × 10−9 S/cm for all the manufactured structures. The structural modifications on organotin (IV) complexes were focused on the electronic nature of the substituents and their ability to contribute to the electronic delocalization via the π system. The presence of the methyl group, a modest electron donor, or the non-substitution on the aromatic ring, has a reduced effect on the electronic properties of the molecule. However, a strong effect in the electronic properties of the material can be inferred from the presence of electron-withdrawing substituents like chlorine, able to reduce the gap energies.

Highlights

  • In recent years, the study of optoelectronic devices, based on organic semiconductors, such as organic photovoltaics (OPVs) and organic light-emitting diodes (OLEDs) has gained the interest of numerous researchers around the globe [1] due to their mechanical flexibility, lightweight, and prospective potential for roll-to-roll manufacturing and low cost [2,3]

  • The materials required for the fabrication of these organic electronic devices (OEDs) in its most simple form, include a transparent substrate, a transparent electrode, a light-absorbing organic active layer, and a counter-electrode

  • The most common substrate used in the fabrication of OEDs is glass, due to its low-cost, commercial accessibility and its ability to protect the device against oxygen and water

Read more

Summary

Introduction

The study of optoelectronic devices, based on organic semiconductors, such as organic photovoltaics (OPVs) and organic light-emitting diodes (OLEDs) has gained the interest of numerous researchers around the globe [1] due to their mechanical flexibility, lightweight, and prospective potential for roll-to-roll manufacturing and low cost [2,3]. Between the MSCs, metal-ion complexes have been studied by means of their molecular structures, magnetic, optical and electronic properties. Their applications in catalysis, supramolecular chemistry, biology and biochemistry. Despite the number of reports in the literature regarding the Schiff bases metal complexes exhibiting non-linear optical (NLO) properties [45,46], few investigations have been devoted to study their optical and electrical properties. Keeping this in mind in the present paper we describe the synthesis and the complete characterization of heptacoordinated. Interfacial films were included to favor contact between the organotin complexes and the electrodes, having a substantial impact on the extraction and collection processes of charges

Materials and Methods
Films and Devices Fabrication
Results and Discussion
Manufacture and Characterization of Films and Optoelectronic Devices
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call