Abstract
It is always preferable to use commercially available software tools to design broadband matching networks for microwave communication systems. However, for these tools, the matching network topology and element values must be selected properly. Therefore, in this paper, a practical method is presented to generate matching networks with good initial element values. Eventually, the performance of the designed matching network is optimized by employing the commercially available computer-aided design (CAD) tools. An example is given to illustrate the utilization of the proposed method. It is shown that the proposed method provides very good initials for CAD tools.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Circuits and Systems II: Express Briefs
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
