Abstract
In this paper, the design of non-flexural components using strut and tie models (STM) is presented. The proposed design procedure of STM is compliant with the British Standards. Two examples related to deep beam and dapped-end beam are given to illustrate the design principles of STM, The same beams are redesigned and detailed by using the conventional flexural theory and local detailing practices. The drawbacks of using the conventional approach for the design of non-flexural components are highlighted.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
