Abstract
The electronics industry is increasingly focused on the consumer marketplace, which requires low-cost high-volume products to be developed very rapidly. This, combined with advances in deep submicrometer technology have resulted in the ability and the need to put entire systems on a single chip. As more of the system is included on a single chip, it is increasingly likely that the chip will contain both analog and digital sections. Developing these mixed-signal (MS) systems-on-chip presents enormous challenges both to the designers of the chips and to the developers of the computer-aided design (CAD) systems that are used during the design process. This paper presents many of the issues that act to complicate the development of large single-chip MS systems and how CAD systems are expected to develop to overcome these issues.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.