Design of Injection Mould for Lithium Battery Heat Dissipation Device Connector Bottom Cover

Abstract

The design process of the injection mould for the Lithium battery heat dissipation device connector bottom cover is described in detail. In the design process, the UG software is used to establish the three-dimensional model of the plastic part, and the mould flow analysis is carried out with the help of the moldflow software to determine the optimal gate position of the plastic part. By determining the injection process parameters of Lithium battery heat dissipation device connector bottom cover material, the design of the cavity layout of the plastic part is completed, and the basic size and mould structure of the mould base are determined. Then, the UG injection mould design guide module was used to carry out the parting design, and the structural design of the mould’s gating system, molding parts, lateral parting mechanism, core-pulling mechanism, ejection mechanism, exhaust system and cooling system was completed in turn. The whole design process improved the efficiency of mould design and saved a lot of time and cost.