Abstract
AbstractHalf‐band filters are important for applications to multirate signal processing and wavelets. Previously, FIR half‐band filters have mainly been treated. However, it should be recognized that the IIR filter can produce frequency characteristics similar to those of the FIR filter with a low order. Also, in the applications of filter banks and wavelets, design of a half‐band filter is needed in which the degree of flatness can be specified arbitrarily. In the present paper, a new design method is proposed for an IIR half‐band filter with an arbitrary degree of flatness. In the present design method, the analytical solution of the filter coefficients is given in the case of a maximally flat filter. Also, in the case of a specified degree of flatness, the amplitude error in the stopband can be specified in the design. Further, the stability of the filter is studied and then the minimum group delay for causal stability is clarified. Finally, the IIR half‐band filter is applied to the design of a two‐channel filter bank and the effectiveness of the present design method is proven. © 2003 Wiley Periodicals, Inc. Electron Comm Jpn Pt 3, 87(1): 10–18, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/ecjc.10114
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Electronics and Communications in Japan (Part III: Fundamental Electronic Science)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.