Abstract
This paper presents a simple approach for designing planar electromagnetic band gap structures. The approach is based on designing a planar band pass filter at a desired center frequency. A simple modification is introduced to the well known design steps of the filter. This modification allows for specifying the high impedance property of the structure, as well as its stop band, using a circuit simulator. The validity of the proposed method is shown by applying it in designing some novel structures. Simulations using circuit modeling, full wave simulators, along with laboratory measurements are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.