Design of Efficient Zeolite Sensor Materials for n-Hexane

Abstract

The effectiveness of several zeolite catalysts was investigated using the cataluminescence (CTL) gas sensor system. Trace amounts of n-hexane in air samples were detected by this method. This research establishes that the specific pore size of the zeolite offers designable environment for selective CTL reaction, and "Lewis-type" basic sites appear to contribute to the catalytic nature of the zeolite surface. By incorporating either Cs+ or K+, the velocity and luminescence intensity of these catalytic reactions increase while going from Na to Cs, according to the basic nature of this group of cations in the following order: Cs > K > Na. The proposed sensor shows high sensitivity and selectivity to n-hexane at a mild reaction temperature of 225 degrees C. Quantitative analysis was performed at a selected wavelength of 460 nm. The linear range of CTL intensity versus concentration of n-hexane was 0.776-23.28 microg/mL (R = 0.997, n = 7) on CsNaY, and 0.776-23.28 microg/mL (R = 0.998, n = 7) on CsNaX, with a detection limit of 0.155 microg/mL (signal-to-noise ratio 3). Interferences from foreign substances such as methanol, ethanol, 2-propanol, acetone, acetonitrile, chloroform, or dichlormethane and other alkanes, aromatics, and alkyl aromatics such as methane, n-pentane, 3-methylpentane, 3,3-dimethylpentane, methylbenzene, ethylbenzene, and sec-butylbenzene were very low or not detectable. Results of a series of GC and GC/MS experiments suggest that the possible mechanism of the reaction is the formation of an unstable transition structure with a four-member ring, and this ring most probably consists of an oxygen atom and a carbonium ion localized on the zeolite suface.