Abstract
To measure the magnetic fields with a Hall probe, accurate alignment needs to be considered. Therefore, we present improvements to the Hall probe measurement system, including cone magnets and a zero-field shield as simulated by the OPERA. The design of the cone magnets of the North-face-North type is greatly helpful to monitor the magnet alignment. The accurate location of the Hall probe doping area should be determined before doing any measurements. In addition, a zero-field shielding tube is used to reset the probe to zero. The results of simulations are reported in this paper.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
