Abstract
AbstractThis paper presents the design of an automatic gain control (AGC) loop for high‐speed communication systems, which can be used in wired, wireless, or optical receiver. The design is performed in 130 nm SiGe BiCMOS technology. A Gilbert cell‐based variable gain amplifier is designed, which shows approximately linear gain control with respect to the gain control voltage. The variable gain amplifier is followed by two fixed gain cascode amplifiers. Then, a full wave rectifier‐based peak detector is designed and analyzed. To reduce the peak detector error, a compensation technique is applied. Finally, an operational amplifier is designed, which is used as voltage adder and comparator. The designed AGC loop is simulated with sinusoidal and pseudorandom binary sequence (prbs) input signal with high frequency signal of 1 to 30 GHz. The simulation results of the AGC loop show that a gain tuning range of 47 dB (−7 to 40 dB) is obtained in this design. It is also seen that the reference signal can be varied from 50 to 200 mV. This AGC works in the input voltage signal range between 3 mV peak and 230 mV peak, and the power dissipation of is 79 mW.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Circuit Theory and Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
