Abstract
An efficient and low cost approach to realise a non-planar dual-polarised log-periodic dipole array antenna (LPDA) using printed circuit board technology is proposed which achieves a high bandwidth and operational frequency. The proposed antenna utilises a very short transition from a coaxial cable to a balanced four-conductor transmission line to realise an ultra-wide bandwidth balun and input impedance matching. An analysis of the utilised four-conductor transmission line alongside its comparison to two-conductor transmission line of a planar LPDA is also presented. Two prototypes of the antenna operating over the frequency ranges of 1–13 GHz and 1–18 GHz were designed, fabricated, and tested. An average gain of 6.7 dBi is obtained. Measured voltage standing wave ratio, cross-polarisation and front-to-back ratio of both prototypes are better than 2.6, −14, and 22 dB respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
