Abstract
This paper presents the design of a control system for sensorless brushless DC motor. The system directly extracts the true back EMF zero crossing point by detecting the voltage difference between the floating phase terminal and the midpoint in the DC link. The commutation signal of the floating phase is obtained by lagging the back EMF zero crossing point 30 electrical degrees. And two motor starting methods are implemented in the system. The experiment shows good motor performance over a wide speed range. Experimental results from a prototype of brushless DC motor control system verify the analytical results and confirm the validity of the system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.