Abstract
This paper describes design, manufacture, and testing of a linerless composite vessel for liquid hydrogen, having 0.3 m diameter and 0.9 m length. The vessel consists of a composite cylinder manufactured by wet filament winding of thin-ply composite bands, bonded to titanium end caps produced by additive manufacturing. The aim was to demonstrate the linerless design concept with a thin-ply composite for the cylinder. The investigation is limited to the internal pressure vessel, while real cryogenic tanks also involve an outer vessel containing vacuum for thermal insulation. Thermal stresses dominate during normal operation (4 bar) and the layup was selected for equal hoop strains in the composite cylinder and end caps during filling with liquid hydrogen. Two vessels were tested in 20 cycles, by filling and emptying with liquid nitrogen to 4 bar, without signs of damage or leakage. Subsequently, one vessel was tested until burst at almost 30 bar.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
