Abstract
AbstractBACKGROUNDThe development of new open‐cell porous electrodes for electrochemical flow cells and reactors is demonstrated through the application of 3D printing. The properties of diverse architectures were investigated, including rectangular, circular, hexagonal and triangular cells with linear porosity grades of 10, 20 and 30 pores per inch (ppi). Specimens were digitally designed, then 3D printed in stainless steel via selective laser melting. After being examined using scanning electron microscopy, they were characterized in terms of volumetric surface area and porosity with the aid of X‐ray computed tomography. Pressure drop measurements were performed over a range of mean linear velocity and Reynolds number, allowing the estimation of Darcy's friction factor and permeability.RESULTSVolumetric surface area estimated from tomography scans was ≤36% higher than the nominal values owing to surface roughness and post‐processing algorithms. By contrast, volumetric porosity obtained by tomography agreed fully with measured values. Triangular architectures afforded additional surface area both digitally and according to tomography. The largest pressure drop was found in circular materials, the triangular ones showing the lowest. The 20 ppi triangular architecture had a volumetric surface area of ≈44.5 cm−1 and a permeability of 2.31 × 10−5 cm2.CONCLUSIONTriangular architectures were preferred as a consequence of their favourable combination of high surface area and high permeability with low mass and reduced digital complexity. This provides a strategy to initiate the optimization of 3D printed porous electrodes for electrochemical flow cells and reactors in novel and niche applications. © 2021 The Authors. Journal of Chemical Technology and Biotechnology published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry (SCI).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Chemical Technology & Biotechnology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.