Abstract
This paper proposes a new kind of quasi-zero-stiffness (QZS) isolation system that has the property of low-dynamic but high-static stiffness. The negative stiffness was produced using two magnetic rings, the magnetization of which is axial. First, the force–displacement characteristic of the two coupled magnetic rings was developed and the relationship between the parameters of the magnetic rings and the stiffness of the system was investigated. Then, the dynamic response of the QZS was analyzed. The force transmissibility of the system was calculated and the effects of the damping ratio and excitation amplitude on the isolation performance were investigated. The prototype of the QZS system was developed to verify the isolation effects of the system based on a comparison with a linear vibration isolation platform. Lastly, the improvement of the QZS system was conducted based on changing the heights of the ring magnets and designing a proper non-linear spring. The analysis shows the QZS system after improvement shows better isolation effects than that of the non-improved system.
Highlights
In many practical examples, an isolator usually shows the vibration isolation effect when the √excitation frequency is over 2 times the natural frequency of the linear isolation system
Nonlinear vibration isolation systems based on the quasi-zero-stiffness (QZS) have been investigated that have the properties of high-static and low-dynamic stiffness
The black line represents the acceleration of the excitation, the blue line is the acceleration of the mass of the QZS system, while the red line is that of the linear
Summary
An isolator usually shows the vibration isolation effect when the √excitation frequency is over 2 times the natural frequency of the linear isolation system. The isolation frequency range will usually be expanded when the natural frequency of the isolator system is reduced, the cost of which is a reduction in the stiffness of the linear vibration isolation system, which causes an undesirably large static deflection [1,2]. To overcome this problem, nonlinear vibration isolation systems based on the quasi-zero-stiffness (QZS) have been investigated that have the properties of high-static and low-dynamic stiffness. In Ishida et al [11], a vibration
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have