Design control and actuator selection of a lower body assistive exoskeleton with 3-D passive compliant supports

Abstract

Physical human–robotic interaction is a crucial area of concern for robotic exoskeletons. Lower weight requirement for the worn exoskeletons limits the number and size of joint actuators, resulting in a low active degree of freedom for the exoskeletons with joint actuators having limited power and bandwidth. This limitation invariably results in reduced physical human–robotic interaction performance for the exoskeleton. Recently several techniques have been proposed for the low active degree of freedom exoskeletons with improved physical human–robotic interaction performance using better load torque compensators and improved active compliance. However, effective practical implementation of these techniques requires special hardware and software design considerations. A detailed design of a new lower body exoskeleton is proposed in this paper that can apply these recently developed techniques to practically improve the physical human–robotic interaction performance of the worn exoskeletons. The design presented includes the exoskeleton's structural design, new joint assemblies and the design of novel 3-D passive, compliant supports. A methodology of selecting and verifying the joint actuators and estimating the desired assistive forces at the contact supports based on human user joint torque requirements and the degree of assistance is also thoroughly presented. A new CAN-based master–slave control architecture that supports the implementation of recent techniques for improved physical human–robotic interaction is also fully presented. A new control strategy capable of imparting simultaneous impedance-based force tracking control of the exoskeleton in task space using DOB-based-DLTC at joint space is also thoroughly presented. Simulation verification of the proposed strategy based on the actual gait data of elderly is presented lastly.